EN

Translate:

World-wide shipping available! Message us for pricing.

  • |
  • Frequently Asked Questions

    1. How do I order these tools?

    You can order directly though this website or you can email us at xpertsigntools@gmail.com. For international shipping prices, you can email us or call us at 877-895-4053.

    2. What size arbor press do I need?

    We recommend a 1 ton arbor press. You can use anything larger, of course, but please note that the Xpert Base might not fit on the larger arbor press.  A 1 ton works well and is much more affordable than larger arbor presses.

    3. Where do I buy an arbor press?

    We have always bought our arbor presses from Harbor Freight. These are usually around $50. Check your mail for a 20-25% off coupon!

    4. Do I need the Xpert Tool Base?

    We highly recommend the tool base as part of your purchase.The Xpert Tool Base was created as a response to customer feedback. It eliminates the need to secure the tool to the arbor press and greatly improves the tools’ performance.

    5. What is the thickest material I can cut with the Xpert Corner Rounder?

    At the moment, with a 1 ton arbor press, you can expect to cut up to 0.080 aluminum. 

    6. What is the thickest material I can cut with the Corner Rounder?

    At the moment, with a 1 ton arbor press, you can expect to cut to .080” aluminum. The finger guard is set at a height to allow a material thickness of 3mm (1/8").

    7. What is the difference between the Hole Punch and the Drilling Fixture?

    The Hole Punch creates a ¼” or ⅜” hole in your material (depending on which one you purchased). 


    The Drilling Fixture allows you to use an ⅛”, ¼”, ⅜”, or ½” drill bit.


    The Hole Punch is used on an arbor press (sold separately). 


    The Drilling Fixture can be used on a drill press or with a cordless drill (more convenient for job sites).


    On the Hole Punch, you can use the guides to inset the hole ¼”, ½”, ¾”, and 1” from the edge or corner of the blank. 


    The guides on the Drilling Fixture can be set every quarter inch up to 2” from the edge or the corner of the blank.


    The Hole Punch is great for cutting through metals, composites, magnetics, etc. 


    The Drilling Fixture works great with aluminum and acrylic panels, pvc, or other substrates, up to ½” thick.
     

    The Drilling Fixture attaches to the drill press platform.  Different sized holes can be created with different drill bits.
     

    You can use the guides to inset the hole up to 2” from the edge or the corner of the blank. ⅛”, ¼”, and ⅜” drill bit bushings are included with this tool. 


    The Drilling Fixture works great with acrylic panels, or other substrates, up to ½” thick.

    8. Do you ship internationally?

    Absolutely! We have shipped all over the world and will continue to do so!